Installing iPad Wi-Fi Home Button Switch
Replace the electronic home button switch on your iPad Wi-Fi.
With one spudger, work your way along the right edge of the iPad, releasing tabs as you go.
Lift the display assembly away from the rear panel assembly by its bottom edge.
Do not attempt to remove the display at this time, as it is attached to the rear panel assembly.
In the following steps, you will disconnect the three cables attaching the display assembly to the logic board. The cables are for the following components:
Ambient Light Sensor
Display Data Cable
Use the edge of a plastic opening tool to flip up the retaining flaps holding the digitizer ribbon cables in their sockets on the logic board.
Be sure you are flipping up the retaining flap, not the socket itself.
Pull the digitizer ribbon cables straight out of their sockets.
Use a plastic opening tool to remove the ambient light sensor connector from its socket by gently prying upward.
Disconnect the display data cable from the main board by flipping up the metal retainer by its black plastic pull tab.
Pull the cable connector away from its socket.
Pull the connector parallel to the face of the logic board.
Remove the display assembly from the rear panel assembly.
|Step 9 — Home Button Switch |
Remove the two T5 Torx screws securing the home button switch board to the display frame.
Remove the home button switch board from the display frame.